NGPC Pocket Flash Cart PCB

Design work started on the cart PCB. Most of the schematic has been drawn up. The card edge connector is missing, but I think Brian or Gerry may come through with that soon. Then, I think Gerry will lay out the PCB based on the schematic and etch a prototype. This will allow me to perfect my VHDL code that will run on the cart.

I’m feeling real good about this. I gave Gerry an early untested version of the VHDL and said that I think there’s about a 15% chance that it will just work on the first try.

Once the prototype works, then we can fab a real board based on the same design.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.